Guide

    Microplastics in Indoor Air: What the Numbers Can—and Cannot—Tell Us

    A 2025 study found high airborne microplastic counts in homes and cars. Here’s what UK building managers should, and shouldn’t, take from the numbers.

    27 October 20267 min read
    Last reviewed:

    A particle count can make an invisible problem feel suddenly concrete. Put a number beside the air in a sitting room, office or car and it becomes tempting to treat that number as a verdict. With airborne microplastics, however, the most useful question often comes before the count: what was the method capable of finding?


    A small French study published in 2025 brought that question into sharp focus. Researchers examined airborne plastic particles in apartments and cars, including particles smaller than those captured in much previous work. Their findings attracted attention because the estimated numbers were high. The more durable lesson for UK building managers is about the limits of measurement, the difference between detection and risk, and how to investigate an emerging concern without promising an answer that the evidence cannot provide.

    Looking below the previous detection window

    The research used Raman spectroscopy, which helps identify materials through their interaction with light. It investigated particles in the 1–10 micrometre range: small enough to be missed when a study concentrates on larger fragments. The analysis comprised 12 environmental samples and four blanks. Those blanks were checks on contamination introduced during sampling or analysis, not four additional occupied spaces.


    This matters because plastics are so common in the environments in which researchers work. A credible investigation must distinguish material collected from the air being studied from material introduced by the process of collecting and analysing it. A highly sensitive method without suitable contamination controls can produce impressive-looking results that are difficult to interpret.


    The reported median concentrations were 528 particles per cubic metre in the apartment samples and 2,238 in the car samples. Most identified particles were below 10 micrometres. But the samples were few, results varied substantially, and the apparent difference between the two environments was not statistically significant. These findings do not establish that cars generally contain four times as much airborne plastic as homes, still less that the same relationship applies across the UK.


    They do establish a useful research question: how much of the picture changes when investigators look for smaller particles? A change in the detection window can change a count even when the environment itself has not changed.

    An estimate of inhalation is not a measurement of harm

    The study also estimated daily inhalation using its measurements and assumptions about breathing and exposure. Such calculations help researchers explore possible scale. They are not a count of particles retained in an individual person's lungs, a clinical test, or a prediction that a particular illness will follow.


    Several steps lie between finding a particle in a sampled volume of air and understanding a health outcome. People move between environments. Their breathing rates and time spent in each place differ. Particles have different sizes, shapes and compositions. Some inhaled material is cleared. None of those distinctions disappears because a headline expresses the result as a large daily total.


    For a UK employer or property manager, importing the French estimate into a report as the exposure of everyone in a building would therefore create false precision. The study is a reason to ask better questions, not a ready-made baseline against which to certify British offices or homes.

    The UK assessment remains cautious

    The UK's Committee on the Medical Effects of Air Pollutants has examined airborne nano- and microplastic particles and fibres. Its statement identifies major limitations in exposure measurement and health evidence. Apart from certain high occupational exposures, the available evidence is insufficient for a comprehensive health-risk assessment. Laboratory particles and doses may also differ substantially from real-world conditions.


    That position leaves room for concern and further research without supporting confident claims that an ordinary indoor concentration has a known clinical consequence. It also means that a result cannot responsibly be labelled safe or dangerous by comparing it with an invented microplastics threshold.


    There is a practical distinction between uncertainty about a particular emerging contaminant and uncertainty about everything in a building. A facilities team can still investigate dust accumulation, poorly understood activities, ventilation problems and recurring complaints. Those are concrete questions even when the toxicological interpretation of an airborne plastic count remains unsettled.

    What an ordinary particle reading tells you

    A PM2.5 result normally describes an estimate of the mass of particles within a defined size fraction. A microplastics analysis asks about material identity. These are different measurements. A rise in PM2.5 cannot, by itself, identify plastic, and a low mass reading cannot demonstrate the absence of small plastic particles.


    The same distinction applies to fibres. Seeing fibres on a surface does not establish their composition or the concentration that was airborne. Counting airborne objects without identifying them does not show that every object is plastic. An investigator needs to state which question the method answers and which questions remain outside its scope.


    For general building concerns, indoor air quality assessment can help establish the occupied conditions, plausible sources and appropriate measurements. It should not be described as a comprehensive microplastics identification service unless that specific analytical scope has been agreed and demonstrated.


    This is particularly important when commissioning work. A brief that simply asks whether a building has microplastics may be technically answerable but practically unhelpful. A better brief explains the concern: a new process, visible material shedding, an unusual dust problem, a refurbishment, or a complaint that follows a particular activity. The investigation can then consider whether identifying polymers would change the decision.

    Start with the building and the activity

    Imagine, as a hypothetical example, an office where staff report more settled dust after a change in cleaning arrangements. A newspaper article about microplastics has prompted concern about the carpets. It would be premature to identify the carpet as the cause or replace it on that basis alone.


    The useful first step is to establish what changed. Were surfaces previously being cleaned more often? Is dust entering during nearby work? Are cleaning activities disturbing deposits while people are present? Have occupancy, furniture or ventilation arrangements changed at the same time? These questions produce a history that a single sample cannot reconstruct.


    Where appropriate, dust monitoring can help investigate the timing and distribution of airborne particulate matter. Its value depends on the measurement objective. It may help distinguish a recurring activity-related rise from background conditions, but it does not automatically identify which fraction is plastic or establish the source of every particle.


    If a material-specific question remains, it belongs in a separate analytical brief. That brief should define the particle sizes sought, how contamination will be controlled, how results will be reported and what interpretation is possible. Specialist analysis is most useful when a result will inform a clear action, rather than merely add an alarming number to an unresolved complaint.

    Make proportionate changes, then assess them

    There is no need to wait for a complete account of microplastic toxicology before addressing an obvious dust-generating activity. Equally, uncertainty does not justify stripping out useful furnishings or making sweeping claims about all synthetic materials.


    A proportionate building response follows the source that can actually be observed. If an activity repeatedly produces dust, consider how it is carried out, whether material is being unnecessarily disturbed, and whether people need to be present. If the concern concerns ventilation, assess how air reaches and leaves the occupied space. If the problem began after a change, examine that change before attributing it to a fashionable contaminant.


    Keep a record of the action and the question it is intended to resolve. A change in cleaning timing might address disturbance during occupancy. A repair might address an identified pathway from an adjacent area. Neither should be presented as a proven percentage reduction in microplastic health risk without evidence supporting that claim.


    For persistent or unusual concerns, a targeted indoor air investigation can bring the activity history, building conditions and sampling questions together. The objective should be an explanation useful to the people occupying the space, including a clear statement of what has not been established.

    Explain the result without overstating it

    Good reporting separates three things: what was measured, what can reasonably be inferred, and what remains unknown. A measured particle concentration belongs in the first category. A plausible relationship with an observed activity may belong in the second. An individual health prediction from a small environmental sample generally does not.


    This approach also makes communication less brittle. A manager who promises that a routine survey will prove an office is free of microplastics has set an expectation the work is unlikely to meet. A manager who explains that the investigation will examine the reported dust problem, identify practical improvements and specify any analytical limitations has offered something more useful.


    The French research remains relevant because it exposes a blind spot in how particles are counted. For UK buildings, the response is to improve the questions attached to the measurements. Smaller particles deserve careful investigation; larger numbers still need careful interpretation.

    Need Indoor Air Quality Testing?

    Get a no-obligation quote. We provide IAQ testing, ventilation assessment and environmental monitoring across London and the South East.

    We use cookies to measure how our site and adverts perform. You can accept or reject non-essential cookies. Privacy policy